Stems
$24.00
When you’ve got to finish your bike off right! The Burgtec Stem Spacers are the perfect finishing kit.
Colour: Burgtec Black
Set contains:
2 x 5mm Spacers
1 x 10mm Spacer
1 x 20mm Spacer
$49.95
This is the Top cap required to run the EDC Tool in your steerer if it has been threaded for the tool. We can tap a thread in store at The Hub or you will need access the required tap. The alternative is to use the new EDC stem which...
$54.95
The EDC Stem Top Cap & Preload Kit includes an EDC ready headset top cap, a headset bearing preload assembly, 40mm of integrated headset spacers, and an EDC steerer plug. When installed into the OneUp Stem it creates an EDC ready stem that does not require threading your steerer tube. How does...
$70.00
This CNC-machined stem is sleek and lightweight.
3D forged and CNC-machined 6061 aluminum
6-degree rise
Oversized 31.8mm handlebar interface
Compatible with composite handlebars
$150.00 from $115.00
The design team for the new Thomson X4 had a tough goal: make a stem better than the Thomson Elite 25.4. Early tests showed us that our competitors 31.8 stems were heavier and weaker than our Thomson Elite 25.4. At Thomson the X4 was not done until it was stronger,...
$120.00
The CAVITY steerer mount stem has become the benchmark by which all DEITY stems are measured. This beloved no–nonsense design has become a top seller, and for good reason! This shorter 35mm reach version of the original CAVITY stem was a direct response to the riders’ need for a shorter...
$139.00
The OneUp EDC Stem allows you to store your EDC Tool in your steerer tube, without threading your fork. It combines an integrated preload system that allows you to adjust your headset preload without loosening your stem. There's a reason why so many EWS Pro Riders use the OneUp EDC...
$159.99
All new COPPERHEAD steerer mount stem - Light enough for All Mountain yet strong enough for slopestyle and everything in between- CNC machined from a solid block of 6061 T6 Aluminum- Exceptionally detailed chamfered edges and channels throughout- Super low 30mm stack height- 31.8mm bore- Available in 35mm, 50mm and...
$190.00
The Renthal Apex combines All Mountain strength, Enduro stiffness and XC lightweight. Unique 240deg handlebar clamps allow much of the stem body material to be removed, whilst retaining the strength and stiffness demanded by modern, wide handlebars. The Apex 35 is fully CNC machined, featuring an oversize centre bore, extensive machining...
$290.00
Everything you need you run the new OneUp EDC stem and tool system without the need to tap a thread in the steerer. Combo Includes: Stem: 35mm EDC Stem Preload Kit Tool - EDC Tool System The OneUp Components EDC Tool System is the clever solution for those who do...
